Analogue-solutions Telemark /-K Manuel d'utilisateur télécharger pdf (Page 21)

analogue Solution – Telemark – 2014 21 | P a g e

Telemark-k MIDI Data Editing

The keyboard / MIID setup can be edited using the buttons and LCD. All the parameters are self-explanatory, but

details are here.

PAGE, PARAM -10, -1, +10, +1

There are six pages of parameters. Each page contains two sets of parameters.

To scroll through the 6 pages of data press the PAGE button. Each press advances you to the next page and will cycle

back to page 0 once you get to page 6. To move the cursor between the 2 sets of data in each page, press the PARAM

button (parameter). Each press will toggle you between the two available parameters.

To alter a parameter's value, first select the parameter, ensuring the cursor is under the appropriate parameter, then

use the +/- buttons to edit the value.

There are four +/- buttons;

-1 decreases data by 1

+1 increases data by 1

-10 decreases data by 10

+10 increases data by 10

OCT-, OCT+

You can quickly alter the keyboard octave setting +/- four values. Octave setting can also be edited via the LCD. The

octave parameter/buttons are used to transpose the keyboard in whole octaves.

Transpose and Octave parameters only affect the keyboard data. That is the note information sent to the voice

circuits and the data sent to the MIDI Out socket. These parameters will not affect MIDI information received at the

MIDI In socket.

STORING PARAMETERS

The new value of any parameter you edit will be lost if you switch off the machine. So ensure you store the setup

before switching off.

Press the PAGE button until you get to the store page. Then Press OCT+ to store the setup. Then the LCD will revert

back to PAGE0.

If you do not wish to store, then just press PAGE again to return to PAGE0

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Pas de commentaire

Analogue-solutions Telemark /-K Manuel d'utilisateur Page 21